1. Improve the comprehensive quality of operators

The machining center is a typical mechatronics product that involves a wide range of knowledge, so operators should have professional knowledge in organic, electrical, hydraulic, gas, and other related fields; The CNC system of the machining center is upgraded and updated very quickly, and it is difficult for operators to master the application of the new generation CNC system without professional training. Therefore, the application of machining centers requires high professional knowledge from operators. So it is also necessary to provide systematic training for operators. When problems occur in the machining center, operators should have analytical skills.

2. Strictly follow the correct operating procedures

No matter what type of machining center it is, it has its own set of operating procedures. This is not only an important measure to ensure the personal safety of operators, but also an important measure to ensure equipment safety and product quality. Therefore, the operator must operate correctly according to the operating procedures. If the machine tool is used for the first time or has not been used for a long time, it should be idle for about 10 minutes first; And special attention should be paid to the sequence and precautions of turning on and off during use.

3. Regularly check the level and accuracy of the machine tool

There are two methods for correcting mechanical accuracy: soft and hard. The soft method mainly relies on system parameter compensation, such as screw reverse clearance compensation, fixed point compensation for positioning accuracy of various coordinate systems, and machine tool reference point position correction; The hard method usually needs to be carried out during machine tool overhaul, such as rail scraping, pre tightening of ball screw nuts, and adjusting the reverse clearance.

4. Regular hygiene cleaning

If the environment around the machine tool is too dirty and there is too much dust, it can affect the normal operation of the machine tool; The circuit board is too dirty and may cause short circuits; Oil and water filter screens, safety filter screens, etc. that are too dirty can cause insufficient pressure, poor heat dissipation, and cause malfunctions.