Due to the high technical content of the processing center, it is more complicated, operating than ordinary machine tools, and shall be operated strictly in accordance with the operating regulations to ensure the normal operation of the machine. Just as the skilled operator is the necessary operating machine to deal with the requirements of the processing path and the characteristics of the machine when you understand several processing tasks. To use the rights and reasonable methods of the processing center, and ensure the normal operation of the processing center, the process of a relatively complete processing center should be established.

1, enter the sequence or turn off: first press the emergency stop switch on the operating panel, then turn on the main power supply and turn on the power switch panel.

2. After booting, check the switch, buttons and keys are normal, flexible, if the machine is abnormal.

3. Check whether the voltage, whether the oil and pressure and the air pressure are normal. Manual lubrication requires manual lubrication.

4. Manually return to the zero (machine origin). If a shaft is in a zero -return position, you must move the shaft to the position 100mm from the origin and manually return to the zero position before zero.

5. When clamping the workpiece, pay attention to whether the pressure board selling on the direction of the workpiece hinders the movement of the tool, and check the white part and abnormal size (if heights). When using the pressure machine to process the workpiece, please pay attention to whether the tools will be tulled to the clamp and so on.

6. Raider to measure and calculate the coordinate system of the parts, and verify and verify the results.

7. It is necessary to verify whether the tools in the program are consistent with the tools in the processing table to avoid error tools. The shape of the inspection and the size of each axis of the front and the rear meet the requirements of the processing process, and if you can hit the workpiece and fixture.

8. Testing and single test cutting, the fast super control switch must be placed in a lower gear.

9. When the testing tool, when the tools of the tools running on the surface of the workpiece, the value of the value of the value of other coordinates of the Z axis of the Z axis is consistent with the power retention of the program with the power of the program.

10. Manual and continuous manual operations. Check whether the location of each switch selected by the selected is correct. Delete the positive and negative direction, find the button, and then operate.

11. Do not wear gloves to touch the rotating mechanical parts. It is best not to wear gloves to operate the switch and button on the panel. You cannot touch the switch and button on the operating panel with a wet hand.

12. When using the borders, this is to better enter the speed of 400? 500 rpm, and then install the points! To prevent the speed from being too fast, remove the border.

13. When the machine is closed, stop the center position in the XYZ shaft, press the emergency stop, and then cut the power.

14. Work every day. Daily maintenance. Check the "transmission log" before work. Before starting the machine, check whether the voltage voltage power supply is in a "automatic voltage adjustment" state, and if the output voltage is normal.