repair

When the carving machine cannot work normally, it may be the reason for its internal components or other reasons. The following problems are generally introduced.

(1) One axis cannot be moved in the three axis. At this time, check whether the corresponding driver block of the corresponding axis is damaged. The inspection method can be used to replace the method: plug off the corresponding air plugs corresponding to the non -moving shaft on the driver corresponding to other dynamic shafts.

(2) If the axle does not move normal after the exchange, it can indicate that the driving block corresponding to the axis has been damaged, and the driver block needs to be replaced. If it is not a shaft, it means that the cable or motor fails to replace the cable or motor. None of the three axes can be moved. At this time, check whether the three -axis aviation plug has been connected to the control box and whether the control box power has been opened. Whether the data cable is connected to the control card with the control box and the computer host. If the above are normal, please contact the factory.

(3) The main axis cannot operate normally. First check the error code displayed by the inverter LED display (see the wrong code item of the inverter instructions)