Time:2023-04-07 Preview:
1. Use gas to blow as much as possible in the rough program, and use oil to spray in the light knife program.
2. Clean the aluminum residue in the equipment before the light knife is injected to prevent the aluminum residue from sticking.
3. During the automatic operation of the device, the user cannot leave the device or check the operation of the equipment on time. If you leave, you must specify the relevant personnel to replace it.
4. If there is a high amount of processing during the production process, you need to use the "single section" or "suspension" to manually milling X, Y, and the most valuable values. Essence
5. During the production process, if the user is found, the user will be suspended immediately. For example, press the "emergency suspension" button or the "reset key" button or adjust the "feed rate" to zero.
6. During the operation of the device, the door is strictly prohibited to avoid flying knives or flying.
7. After the workpiece is picked up, the burrs must be cleaned in time.
8. At get off work, the user must handle the personnel handling in a timely manner to ensure that the subsequent processing can be carried out normally.
9. Before shutting down, make sure that the knife library is in the initial position, XY's most axis is stopped at the center of the place, and the power and total power supply on the device operate panel will be turned off in turn.
10. When encountering thunderstorm weather, be sure to stop the power immediately.
·CNC processing comparison of the advantages of 3D printing ·CNC processing thread method introduction ·Do you know how to maintain the metal die casting mould? ·How to make the five -axis CNC processing simple ·Technical requirements for stamping the machining mold for stamping hardware ·Advantages of metal essence technology ·How to classify hardware stamping molds ·The Processing Method of CNC Machining Parts' Surface ·Do you know how to test the accuracy of the Longmen milling machine? ·How to Prevent Rust after Hardware Spraying