Special axis characteristics check 1. Select low, medium and high -speed operation. The main axis continues to run five times, and then shut down to check the coordination ability and stability of its posture. In addition, the output power in the load table indicates whether it is in line with the regulations. 2. Type and typing of manual data information can slowly increase the spindle from low speed to a large allowable speed ratio. Check whether the speed ratio is normal, and generally may not exceed 10%. In addition, check the spindle speed ratio. Watch the noise, vibration, and warming of the main axis is normal. After 2 hours of high -speed operation, the main axis is heated to 15 "C. 3. In order to check the coordination ability and stability of the spindle posture, the main axis can continue to shut down 5 times.

Zero -point inspection of machinery and equipment: 1. CNC lathes of the column processing management center CNC lathe stable stability school pair. The soft limit is generally decided by the main parameters of the system. According to the main parameters of the system software, the soft limit stability can be performed. The hard limit switch is determined by the limit switch settings set at the axial limit switch in each. The stability of the hard limit switch is decided by the stability of the limit switch. 2. Check the stability and accuracy of the zero point of the return on the back point method, and check the zero -zero characteristics of each entry shaft.

Inspection of the axis: 1. The manual actual operation is low, medium, fast, and rapid movement of the axis. The proportion of inspection is appropriate, whether it is stable and stable when moving, and whether there is noise. 2. The actual operation of the manual data information (MDI) actual operation can detect whether it is normal for the GOO and GOL command function to quickly move and the feed rate. Examination of the knife change equipment: Carry out the CNC blade swap posture by manual method. Check whether the posture of catching knives, knives, and knives is accurate and appropriate. The CNC Machining Management Center is adjusted to conduct inspection methods for inspection methods. When there are deviations, adjust the schedule of the robotic arm, the part of the rubber branch of the movement of the robotic arm or the part of the disassembly and replacement knife.