Standing is mainly used for large parts, and the main axis is standing. The operating table uses a dynamic pressure guide rail, and the spindle radial direction is used for double -column cylindrical roller bearings. The vertical blade is equipped with a pentagonal blade, and the side of the side of the side is equipped with a square blade and two blade frames. All the blade racks are hydraulic balance.

When applying equipment, we generally pay attention to the maintenance and maintenance of CNC to make a long -term use of the lathe, and will not affect processing and production power. When the equipment is suspended, the noise will be announced, and the total power supply of the workshop will go to check the inspection of the power system for the power system. The position of the active air circuit breaker is corroded by the humidity in the switch box. In addition, the three -phase contacts only need a small part, followed by the capacity of the power transformer in the workshop small and overloaded.

A crystal tube of CNC ride has been burned. Checking the driving circuit. Whether the B -phase hair pulse is short, only a quarter of the normal trigger pulse amplitude, which further proves that the operation of the amplifier tube in the B phase of the T3 in the B phase of the B phase is abnormal. The result of the lack of phase in the state of the device's crystal tube is different from the state of the inverter. Dit, and the previous crystal tube will bear back pressure and close. At this moment, problems will occur when the crystal tube is closed, and it is in a state of positive obstruction for a long time.

Assuming that the voltage supply system in the workshop is normal and not firm, the thyroid control may not burn out. The voltage of the power grid is not firm, the transformer capacity of the workshop is small, the overload operation, the trigger pulse amplitude of the BTE polar group is small, and the damage to the main switch box of the workshop power supply causes this problem.