(1) The safety operation regulations of the machining center must be followed.

(2) Before work, it is required to wear protective equipment and tie the cuffs according to regulations. It is not allowed to wear scarves, gloves, ties, or aprons. Female workers should wear their hair braids inside their hats.

(3) Before starting the machine, check whether the tool compensation, machine zero point, workpiece zero point, etc. are correct.

(4) The relative positions of each button should meet the operational requirements. Carefully prepare and input CNC programs.

(5) To check the operation status of the protection, safety, signal, position, mechanical transmission, electrical, hydraulic, digital display and other systems on the equipment, cutting can only be carried out under all normal conditions.

(6) Before machining, the machine tool should be tested for operation, and the lubrication, mechanical, electrical, hydraulic, and digital display systems should be checked for proper operation. Cutting can only be carried out under normal conditions.

(7) After the machine tool enters the processing operation according to the program, operators are not allowed to touch the moving workpiece, cutting tools, and transmission parts, and are not allowed to transfer or take tools and other items through the rotating parts of the machine tool. CNC machining center

(8) When adjusting the machine tool, clamping workpieces and tools, and wiping the machine tool, it is necessary to stop the machine.

(9) Tools or other items are not allowed to be placed on electrical appliances, operating cabinets, and protective covers.

(10) It is not allowed to directly remove iron filings by hand, and special tools should be used to clean them.

(11) If abnormal situations and alarm signals are found, the vehicle should be stopped immediately and relevant personnel should be checked.

(12) It is not allowed to leave the work position while the machine tool is running. If you need to leave for some reason, place the workbench in the middle position, retract the tool bar, stop the machine, and cut off the main machine