Time:2023-07-11 Preview:
The mold processing center has an automatic knife replacement equipment, and the knife is an automatic tray exchange equipment. After one installation, these equipment can do everything possible to complete the processing requirements of different parts of the same workpiece, and do not do it. The manufacturing cycle, improve the goals of the processing accuracy of the product.
Because the technical content of the mold processing center is higher, and the operation of the machine tool is more messy, it should be operated strictly according to the operating regulations to ensure the normal operation of the machine. When the operator understands the processing parts before operating the machine, it handles the path and machine characteristics. Applicable to parts
Small and medium -sized production with cluttered shapes, high accuracy requirements, and frequent product replacement. In addition to the exterior of the various parts that can be milling that can be milling machines, it is also possible to apply for various flat outlines and three-dimensional outlines of 2-5 coordinates.
The poor processing accuracy of the mold processing center is mainly manifested in: the inner holes processing appearance of high roughness value, the inner hole of the hinge is not round, the pore position accuracy is poor, the inner and outer surface of the hole has obvious edges, the rear pores of the re -rear hole The center line is not straight, the pore diameter is increased, and the aperture is reduced.
1. High inner hole appearance roughness value occurs: Machining has high appearance roughness in the inner hole, and there are many reasons. Perhaps because of high cutting speed, inappropriate selection of cutting fluid, too large corners of the hinge knife, too large corners, rectus holes The balance is too large, the balance of the rectus holes is uneven or too small, the blade mouth is not sharp, the hinge blade is too wide, the ducts are not smooth when the rectity is not smooth, and may be selected by the selected milling tools and parts. Data do not match the reasons.
The twists and turns of the hinge blade are adhered to dandruff tumors, the hinge blade mouth is poor when the blade grinds, and the selection of cutting fluid is not appropriate. There may be the problem of the CNC machine tool itself. The above problems occur.
3. Reasons for the accuracy difference of the hinge -out square position: Perhaps it is formed by the fact that the guidance is worn, the guidance bottom is too far away from the workpiece, the length of the guideline is short, the accuracy is poor, and the main shaft bearing loosening is formed.
·CNC lathe processing process division ·Method of checking stamping shots during hardware processing ·The advantages and work content of CNC ·CNC composition ·How does the CNC processing center choose a tool reasonably? ·Problems that do not need to be considered in the processing process of ordinary machine tools ·What is the reason for the deformation of CNC high -precision parts ·The hardware spray paint can test the storage deterioration problem from several aspects ·Where does the CNC refined carving machine manufacturer's refined machine maintenance need to start? ·How to develop the CNC part processing process