Quick CNC processing can use the main shaft bearing of the straight -knotting machine tool and the main axis of the machine tool. The vast majority of other machine tool spindle bearing requirements are required to reach the basic transmission ratio of non -high -speed CNC processing management office. The rapid CNC processing machine tool's main shaft bearing transmission ratio cannot be at least less than 10000rpm, so the high transmission ratio can only be exceeded by most of the main shaft bearing and the main axis of the machine tool.

The requirements for milling into the knife of the rapid CNC processing management office: In the processing center, it can be said that improving the processing center milling and leaving knives is equivalent to improving the high efficiency of production and manufacturing processing. The fast CNC processing management center is the same. The fast CNC processing milling and the knife is generally 20-40m/min. Of course, the milling knife is fast and it is not no.

The sound use of AC servo motors has made fast CNC machining a qualitative leap. It often improves comprehensive improvement in the efficiency of manufacturing and processing and manufacturing and processing. The driving method of AC servo motor is a non -touching immediately controller. There are fewer mobile prefabricated components, and there is no distorted deformation difficulty. Using this type of professionalism, the production and processing center production and processing exceeds the level that traditional roller screws cannot exceed. The AC servo motor has high speed and deceleration characteristics. The acceleration is 2G. It is 10-20 times that of the traditional controller machine equipment. The speed of the knife is 4-5 times that of the traditional.

How to carry out the CNC processing process?

(1) For parts that are prone to processing deformation with rough and precise processing, it must be carried out because of the deformation that will be caused after rough processing. Separation.

(2) The processing part of the processing site is aimed at many parts with many processing content. It can be divided into many parts of the processing according to its structural characteristics, such as internal shape, exterior design, slope, or floor diagram. Generally, processing plane maps, precise positioning planes, and then processing holes; first processing simple three -dimensional geometry, and then processing complicated three -dimensional geometry; first processing parts with lower precision precision and then processing precision standards.