News

Provide customers with high-quality hardware and electronic product services

Home  》  News  》  Industry News

CNC security operation and maintenance regulations

Time:2023-05-25 Preview:


1. Open the power switch and check whether the operating panel starts. Open the door indicator light.


2. Open the emergency button, press the start -up key to start the machine tool, close the door, open the door indicator light, press the start -up key three -axis original point to zero.


3. View the operation screen to check the original three axis of the three axis of the three axis, and start the main shaft 4000 warming machine for 5 minutes to check whether the machine tool is connected to the computer folder.

4. When the bumps are touched, the spindle speed must not exceed 600 rpm.


5. The main axis of the CNC carving and milling machine is strictly forbidden to exceed the limit speed of the machine tool.


6. During the processing of machine tools, you must not open the protective door to prevent the iron dander from flying out of damage.


7. When installing a knife manual, be sure to check whether the tool is broken and the method of clamping is correct.


8. No debris and activity utensils are allowed in the machine tool workbench.


9. Quality problems occur during processing, whether there is a problem with the program or the processing operation, it is necessary to report it truthfully.


10. When the carved and milling machine runs the foundation surface in the Z axis, the Z axis must be entered in the G36T01 without lifting the knife, and then enter the MO6T01 in order. You must go to the knife in order.


11. Check the guidance oil every day, check the main axis lubricating oil and hydraulic oil every week, and refuel the amount of oil less than half of the cursor.


12. The machine tool was cleaned once in 15 days, and the knife was covered.


13. Wash the main axis once a week to keep it clean, non -rust and rust, and ensure the coaxiality of the knife cover during the rotation process.


14. Keep the machine tool and the surrounding environment clean every day, and clean up the iron dumbs and copper dolls of the whole machine every week.


15. Check all the tools every day. If you find the knife tip, change the tool in time, and hand over to the class.


16. Check whether there are copper crumbs and iron crumbs before using the pairing knife. You should cover the blade with the corresponding lid when you do not need to use the blade.


17. All the tools should be provided in advance before the workpiece is on the machine.


18. When processing the workpiece, check the confirmation of the workpiece and processing processes, and communicate with the programmer in a timely manner.


19. The workpiece will be checked before the machine is off the machine. If the problem is found, it will be solved in time.