1. CNC processing process is too scattered

The reason for this problem is that they are afraid of complexity (referring to preparation time), simple programming, simplified operation processing, and using a knife processing to adjust the knife and get used to ordinary processing. In this way, the quality (position tolerance) of the product is not easy to guarantee, and production efficiency cannot be played well. Therefore, CNC processors and operators should be fully familiar with CNC processing knowledge, try more to master relevant knowledge, and use process concentration methods to process as much as possible. A few times can naturally reflect its advantages. After the process concentration is adopted, the unit processing time increases. We arrange the two devices face -to -face layout to achieve one person operating two devices. The efficiency has been greatly improved, and the quality is also well guaranteed.

2. CNC processing order is unreasonable

Some CNC machining operators take into account some of the prepared issues and often arrange the processing order of processing very unreasonable. CNC machining is usually processed according to the requirements of general mechanical processing technology, such as rough first, then thin (swords), first inside, and reasonable selection of cutting parameters. In this way, quality and efficiency can be improved.

Use G00 (G26, G27, G29) to quickly position instructions G00 instructions to brings great convenience to programming and use. However, if the settings and use are improper, it will often cause adverse consequences such as excessive speed setting to generate over zero overching, decreased accuracy, and device guide surface strain. Back to zero routes, it is easy to cause safety accidents that collide workpieces and equipment. Therefore, when considering the use of G00 instructions, it should be considered to be full and not at will.