The phenomenon of stamping parts may appear in the process of production and processing. This may be a combination of one or multiple reasons for the following reasons:

Improper designs of the mold: The design and manufacturing of the mold may be defective, resulting in the production and distortion during stamping.

Improper punching equipment: Improper operation of the punching equipment may also cause the stamping parts to flip and distort. For example, using improper parameters or incorrect punching operating programs on the bed may cause stamping parts to distort.

Improper quality of materials: Improper quality of the material may also cause stamping parts and distortions. For example, parameters such as the thickness, hardness, and toughness of the material do not meet the requirements, and it may produce distortions and turning materials during the stamping process.

Improper pressure during processing: During the processing process, if the pressure is too large or too small, it may cause the stamping parts to flip and distort.

Improper processing speed: Excessive processing speed may also cause stamping parts and distortions. For example, during processing on the fast punch, due to the impact and stress of the material, the stamping parts may be distorted and rolled.

In order to avoid flipping and distortions of stamping parts, it is necessary to comprehensively inspect and optimize molds, punching equipment, materials, processing speed, and operating procedures. At the same time, it also needs to be fully tested and tested to the hedging parts to ensure that its quality meets the requirements.