1. Checking and adjustment of pull -up models: The pull -up mode needs to be checked and maintained in time to reduce the emergence of high -quality vehicle hardware processing and maintain stability. The general method is to use the sample to check the bond scratches on the edge of the edge and the condition of the processing surface (cavity arc, mold arc).

2. 

2. Checking and adjustment of the cutting mold: The main reason for the convex stamping process after the cutting part of the hardware stamping part is the fan under the cutting conditions, so the fan must be turned off before stamping to prevent convexness.

3. Appropriate machine speed: For semi -automatic pull -up production, when the deep model is located in the upper mode and the robot speed is very fast, the burrs will fall in the upper part of the mold seat, causing the bumps of metal stamping parts. In order to prevent this problem, we can do product outlet experiments before production, and reasonably set up the speed of robotics and the angle of the dismissal, so that they will not encounter products and modeling.

4. Check the cross section: When cutting the pipe, the damage of the cutting mold will cause many fine fans to adhere to the knife mouth. Therefore, before processing and production of high -quality stainless steel hardware, the second cross section must be checked in the material area or stamping line, and the burrs must be removed when cleaning the board.

5. Inspection of board cleaning equipment: Before metal stamping production, it is necessary to check, repair, clean and precipitate at the same time to make the cleaning board more effective. This is also very necessary. It also needs to pay attention to the quality of roller gaps and clean oil.