Features of CNC vertical lathes: CNC vertical lathes belong to large machinery and equipment, which is used to process large and heavy workpieces with large radial size and relatively small axial size, and complex shapes. You can also use additional devices to process car thread, car ball, imitation, milling and grinding. Compared with, the installation of workpieces in the decorative decoration of the bedtime lathe. The main axis of the vertical lathe is vertical layout, and the table table on the workbench is in horizontal plane. Therefore, it is more convenient for the installation and finding of the workpiece. This layout alleviates the load of the spindle and bearings, so the vertical lathe can maintain work accuracy for a long time.

(1) Do it seriously at work:

1. The hair surface of the workpiece is not allowed to be directly placed on the work table, and the pad or spiral top support is used; other operations are strictly prohibited to use other operations such as hammering correction workpieces, welding workpieces, and so on.

2. When looking for a positive workpiece, you can only move the workbench to find positive low speeds, and you are not allowed to find positive.

3. When starting and stopped the workbench, the workbench stops and can only move with the hand. It is strictly forbidden to use pedals.

4. When the workbench rotates, it is not allowed to do the beams and moves quickly.

5. When the beam is moved, the clamping device must be released first. After each decrease of the beam, a little raises should be raised to eliminate the screw and snail gap.

6. Do not allow the sliding pillow of the straight knife rack and side blade to extend for a long case for gravity cutting and processing; use vertical blade racks for processing, especially when gravity cutting, the beam should be reduced to close to the work. In the position.

7. During disconnection cutting processing, appropriately reduce the amount of swords and the speed of the workbench.

8. The operating rod must be pushed to the prescribed position during the transmission. If the gear is not closed, the micro -movement should be adjusted after work, and the "opening and stopping" handle is not allowed to move the workers' platform.

(2) After work, there are two vertical blade machine tools, which should be symmetrically parked at the two ends of the beams; a vertical knife can be parked in the middle of the beam; It should be moved to the lower end of the pillar.