When processing the CNC high -precision parts CNC lathes, it generally increases the harm of cohesion. Tighten the parts with a three -claw or four -claw card of the lathe, and then terminate the processing of mechanical parts. In addition, the clamping force must exceed the cutting speed of the mechanical equipment to ensure that the parts are not loose and reduce the internal diameter .. Placing the raw cutting speed to increase and expand, and then decrease. This type of work capacity makes mechanical parts stable during the entire processing process. As everyone knows, after the three -claw or four -claw card is loosened, the processing parts will be very different from the original. Some have irregular graphics, and some have elliptical shapes, which mainly show a large error. During the whole process of processing, be sure to pay attention to some common problems above. Because in the work, it is very easy to cause the problem that the focus is not concentrated. The problem will immediately endanger the quality of the product. Therefore In the case of production and manufacturing, you need to pay attention .. It will undoubtedly be processed immediately. The device uses a high torque motor. The output of the motor can concentrate the characteristics of the main axis. High efficiency and high accuracy of the score disk contains 8 fuel duct connections. One standard air pressure is strict and highly active. application.

What should large and medium -sized CNC processing manufacturers pay attention when processing mold shellfish

1. Prevent vertical knife. There are two types of thick -bottomed cylindrical car blades, one is the inner pores, and its edge is but the management center.

2. In the cutting slope parts, if you find that the thermal treatment process of the parts is not very good, there are cracks, and the mechanism is not well -proportioned, processing should be terminated to prevent the construction time.

3. When the cutting mold shellfish is a very complicated slope, it is generally necessary to have a longer period of time.

4. When the ball knife is cut, the cutting amount at the sharp knife is very low.